Expansion Panels
Model XM-2
The XM-2 is the expansion panel for the
BMPlus3000 series control panels.
The XM-2 will allow the original (3) three zone panel to be expand 2
zones at a time. The XM-2 comes with a "plug-and-play" cable that will
connect to the main zone panel.
The advanced ZXM-2 Expansion Module allows
you to easily add additional zones to the
UZC4
Zone Control System. You can gain up to 16 additional zones for a total
of 20. The robust and superior design, intuitive firmware, simple setup
options, and easy to understand wiring, makes the UZC4 Zoning system
the Contractors dream. Combined with EWC motorized dampers and practically
any off-the-shelf heat/cool, heatpump or Multistage thermostat, EWC
Controls once again proves to be the innovative leader in the residential
& light commercial Forced Air Zoning industry.
- Remote selector switch for use with ST series ULTRA-ZONE Control
panels. This switch replaces the zone 1 thermostat subbase if separate
remote system control is desired. 4 wires required.
- The ZXM-2 Expansion features automatic changeover from any thermostat
allowing for individual zone comfort from the HVAC system.
- Compatible with most Off the shelf 1 or 2 stage Conventional
Heat/Cool or Heat Pump Thermostats. All Mechanical,Digital/Electronic,
Dual Mode, and Internet Compatible Thermostats that operate on 24vac.
Battery powered or Power robbing thermostats that draw less than
20 ma of current are also accepted.
- The ZXM-2 Expansion Module can add up to 16 zones with 1 to
8 expansion modules on a UZC4 control system.
- The STATUS LED pulses as a steady heart beat to indicate active
Micro- processor status.
- LEDs indicate which dampers are open.
- Operates on 24vac power supplied from a separate transformer,
tied to the ZMX2. Power is supplied to the ZXM2 through the bus
cable. (Damper motors are isolated from the UZC4 and MUST be powered
by a separate 24vac Transformer.)